Description
#ANDYSMANCLUB Car stickers that you apply on the outside off your car.
Peel & Stick Instructions
For the best results, apply the stickers to a clean, dry exterior surface of your car.
- Clean the surface
Wash and dry the area thoroughly. Remove any dirt, dust, grease or wax. Make sure the surface is completely dry before applying. - Prepare the sticker
Before peeling, gently rub over the sticker with your fingers or a flat card to ensure the design is firmly attached to the transfer film. - Peel off the backing paper
Slowly peel the backing paper away from the sticker, starting from one corner. The design should remain attached to the clear transfer film. - Position the sticker
Carefully position the sticker on the car. Take your time to make sure it is straight and in the desired location before pressing it down. - Apply the sticker
Press the sticker firmly onto the surface, working from the centre outwards. Smooth over the entire design to remove air bubbles and ensure good adhesion. - Remove the transfer film
Slowly peel the clear transfer film away from the sticker at a low angle. If any part of the design begins to lift, stop and press it back down before continuing. - Press over
Once the transfer film has been removed, gently press over the entire sticker again to ensure all edges and details are securely attached.
Important
- Apply in dry conditions, ideally when the temperature is above 10°C.
- Avoid applying to wet, dirty, waxed or freshly polished surfaces.
- Do not wash the car or use a pressure washer for at least 24–48 hours after application.
- Avoid rubbing or scratching the sticker when cleaning the vehicle.
- For best results, allow the adhesive to fully bond before exposing it to heavy rain or washing.




William yeaman –
Wen use getting more in ? #ANDYSMANCLUB Car Stickers for the outside off the car
Baron Von Shnoodlehouzer –
I have these on my camper and they look good, I bought the inside ones for my car and they don’t look so good…when are these back in stock?